SIIG ID-DS0711-S1 Guida di Installazione Scaricare il pdf (Pagina 10)

Device Server Updated

Press the Update button after you complete your changes.

The Serial over IP Ethernet Device Server will save all setting

into internal non-volatile memory and then reboot. The

Web Console webpage will refresh in around 5 seconds.

NOTE: If Controller Updated/Now restarting

doesn't show up after clicking the update button,

this means the configuration page may be left

idling too long and it timed out, so no update was

performed. Important: If the domain of the RS-

232/422/485 Serial over IP Ethernet is different from

that the connected PC, the login page won't appear

until the Serial Device Server's gateway address is

corrected.

Factory Default Setting

1. Press and hold the reset button as you power on the

Serial over IP Ethernet Device Server for 3 seconds, then

release the reset button.

NOTE: Avoid pressing the reset button for over 5

seconds, this may cause the Serial over IP Ethernet

Device Server to disconnect. In this case, power off

then power on the RS-232/422/485 Serial over IP

Ethernet and repeat the default setting steps.

2. The LAN port's activity LED would blink for a

while, which means the Serial over IP Ethernet Device

Server had been set back to the default settings.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Nessun commento

SIIG ID-DS0711-S1 Guida di Installazione Pagina 10